Dzakiya  Nur Yuniar; Fikra Titan Syifa; Nur Afifah Zen

doi:10.58436/jeepa.v2i2.1278

Authors

Dzakiya Nur Yuniar Institut Teknologi Telkom Purwokerto
Fikra Titan Syifa Institut Teknologi Telkom Purwokerto
Nur Afifah Zen Institut Teknologi Telkom Purwokerto

DOI:

https://doi.org/10.58436/jeepa.v2i2.1278

Keywords:

Internet of Things, Turbidity, Blynk Cloud, ESP8266

Abstract

The research objective is to design an IoT-based rice field irrigation turbidity monitoring system, where later farmers can monitor water turbidity and control the Internet of Things (IoT) through Turbidity sensor processing and the ESP8266 module produced by Relay and cloud Blynk processing. The research flow starts from a literature search, the software design process compiles program scripts for each component that has been programmed through the Arduino IDE application, then creates Blynk which is used to monitor or monitoring the turbidity of irrigation water in real time. After designing the hardware and software, the next stage is system testing, if there are constraints and the results are not appropriate, then the hardware and software design is carried out again until the test is successful and the data results are appropriate, then proceed to the next stage of making the test data results. The research results of the Water Turbidity Monitoring System and Rice Irrigation Ditch Control Using Blynk have been successfully designed and functioning properly. The turbidity sensor works well with sensor readings that pass the range of 10 to 70. If the sensor value is less than 10, the water is detected as clean, but the value is more than 70, then the water is detected as cloudy or dirty. Findings Quality of service (QoS) research shows unsatisfactory or poor results in the delay, packet loss, and throughput components, which are caused by poor internet connectivity.

References

B. E. Cahyono, “Karakterisasi Sensor LDR dan Aplikasinya pada Alat Ukur Tingkat Kekeruhan Air Berbasis Arduino UNO,” J. Teor. dan Apl. Fis., vol. 7, no. 2, pp. 179–186, 2019, doi: 10.23960/jtaf.v7i2.2247.

N. F. Winaji, I. D. Wijaya, and E. N. Hamdana, “Rancang Bangun Sistem Monitoring dan Controlling pada Budidaya Jamur Tiram Berbasis IoT ( Internet Of Things ),” Semin. Inform. Apl. Polinema, pp. 20–24, 2020.

R. Rizky, Z. Hakim, A. M. Yunita, and N. N. Wardah, “Implementasi Teknologi IoT (Internet of Think) pada Rumah Pintar Berbasis Mikrokontroler ESP 8266,” J. Teknol. Inf., vol. 4, no. 2, 2020, doi: 10.36294/jurti.v4i2.1452.

V. Gupta, S. Khera, and N. Turk, “MQTT protocol employing IOT based home safety system with ABE encryption,” Multimed. Tools Appl., vol. 80, no. 2, 2021, doi: 10.1007/s11042-020-09750-4.

Y. Jayusman, I. Faisal, and R. Zaneal, “Perancangan Prototype Kendali Lampu Berbasis Internet of Things (Iot) Dengan Nodemcu Esp8266 Dan Voice Recognition Pada Smartphone,” J. Teknol. Inf. dan Komun., vol. 9, no. 1, pp. 15–25, 2020.

M. Marisa, C. Carudin, and R. Ramdani, “Otomatisasi Sistem Pengendalian dan Pemantauan Kadar Nutrisi Air menggunakan Teknologi NodeMCU ESP8266 pada Tanaman Hidroponik,” J. Teknol. Terpadu, vol. 7, no. 2, 2021, doi: 10.54914/jtt.v7i2.430.

J. Park, K. Park, K. Han, and K. Park, “Design and implementation of 2 channels turbidity sensor modules,” 2013, doi: 10.1109/URAI.2013.6677307.

J. Naismith, “Membrane integrity - Direct turbidity measurement of filtrate from MF membrane modules at an operating potable water treatment plant,” Desalination, vol. 179, no. 1-3 SPEC. ISS., 2005, doi: 10.1016/j.desal.2004.11.052.

M. N. Le Couturier, N. T. Grochowski, A. Heathershaw, E. Oikonomou, and M. B. Collins, “Turbulent and macro-turbulent structures developed in the benthic boundary layer downstream of topographic features,” Estuar. Coast. Shelf Sci., vol. 50, no. 6, 2000, doi: 10.1006/ecss.1999.0602.

M. M. R. Hidayatullah, “Keasaman Dan Kejernihan Air Berbasis Arduino Uno R3,” J. Penelit. Univ. 17 agustus 1945 surabaya, no. 45, pp. 1–6, 2021.

A. Rahman and A. N. Salim, “Sistem Kendali pH dan Kekeruhan Air pada Aquascape menggunakan Wemos D1 Mini Esp8266 berbasis IoT,” J. Teknol. Terpadu, vol. 8, no. 1, pp. 22–30, 2022.

A. P. Manullang, Y. Saragih, and R. Hidayat, “Implementasi Nodemcu Esp8266 Dalam Rancang Bangun Sistem Keamanan Sepeda Motor Berbasis Iot,” JIRE (Jurnal Inform. Rekayasa Elektron. , vol. 4, no. 2, pp. 163–170, 2021.

S. Ratna, “AIR MANCUR OTOMATIS DENGAN MUSIK BERBASIS ARDUINO,” Technol. J. Ilm., vol. 10, no. 4, 2019, doi: 10.31602/tji.v10i4.2359.

A. Abadi, R. Widya, and Julsam, “Rancang Bangun Pemutus Tegangan Pada Kwh Meter Pelanggan Pln,” J. Andalas Rekayasa dan Penerapan Teknol., vol. 1, no. 1, 2021.

A. Budiyanto, G. B. Pramudita, and S. Adinandra, “Kontrol Relay dan Kecepatan Kipas Angin Direct Current (DC) dengan Sensor Suhu LM35 Berbasis Internet of Things (IoT),” Techné J. Ilm. Elektrotek., vol. 19, no. 01, pp. 43–54, 2020, doi: 10.31358/techne.v19i01.224.

C. Sari, A. Zaki, and I. R. Juliana, “Prototype Sampah Otomatis untuk menunjang Pola Hidup Sehat di era New Normal,” ELECTRA Electr. Eng. Artic., vol. 1, no. 1, 2020, doi: 10.25273/electra.v1i1.7739.

R. R. Prabowo, K. Kusnadi, and R. T. Subagio, “SISTEM MONITORING DAN PEMBERIAN PAKAN OTOMATIS PADA BUDIDAYA IKAN MENGGUNAKAN WEMOS DENGAN KONSEP INTERNET OF THINGS (IoT),” J. Digit, vol. 10, no. 2, p. 185, 2020, doi: 10.51920/jd.v10i2.169.

P. E. Kresnha, S. N. Ambo, and Y. Sosrowiguno, “Smart Outdoor Hidroponik Dengan Pengaturan Penyinaran Matahari dan Hujan Berbasis Mikrokontroller,” J. Sains, Teknol. dan Ind., vol. 16, no. 1, p. 77, 2018, doi: 10.24014/sitekin.v16i1.5802.

R. Hamdani, I. H. Puspita, and B. D. R. W. Wildan, “Pembuatan Sistem Pengamanan Kendaraan Bermotor Berbasis Radio Frequency Identification ( Rfid ),” Indept, vol. 8, no. 2, 2019.

R. Priyanka and M. Reji, “IOT based health monitoring system using blynk app,” Int. J. Eng. Adv. Technol., vol. 8, no. 6, 2019, doi: 10.35940/ijeat.E7467.088619.

I. Syukhron, “Penggunaan Aplikasi Blynk untuk Sistem Monitoring dan Kontrol Jarak Jauh pada Sistem Kompos Pintar berbasis IoT,” Electrician, vol. 15, no. 1, 2021, doi: 10.23960/elc.v15n1.2158.

P. Serikul, N. Nakpong, and N. Nakjuatong, “Smart Farm Monitoring via the Blynk IoT Platform,” 2018 Sixt. Int. Conf. ICT Knowl. Eng., 2018.

A. H. M. Nasution, S. Indriani, N. Fadhilah, C. Arifin, and S. P. Tamba, “Pengontrolan Lampu Jarak Jauh Dengan Nodemcu Menggunakan Blynk,” J. TEKINKOM, vol. 2, pp. 93–98, 2019.

M. A. Prasetyo and H. K. Wardana, “Rancang Bangun Monitoring Solar Tracking System Menggunakan Arduino dan Nodemcu Esp 8266 Berbasis IoT,” Resist. (Elektronika Kendali Telekomun. Tenaga List. Komputer) Vol., vol. 4, no. 2, 2021.

K. A. Abdurahman, R. Munadi, and A. I. Irawan, “Perancangan dan Implementasi Hidroponik Berbasis Internet of Things (IoT) Menggunakan Protokol HTTP,” e-Proceeding Eng., 2020.

A. Budiman, A. Sucipto, and A. R. Dian, “Analisis Quality of Service Routing MPLS OSPF Terhadap Gangguan Link Failure,” Techno.Com, vol. 20, no. 1, 2021, doi: 10.33633/tc.v20i1.4038.