MODELING THE CONTROL PANEL CIRCUIT FOR NICE 3000 ELEVATOR 5 FLOORS USING ELECTRICAL CONTROL TECHNIQUES SIMULATOR SOFTWARE

Authors

  • Mohammad Zidan Alfariki
  • Rizky Mubarok

Keywords:

Elevator/ lift, Kontrol Panel NICE 3000, Software Eletrical Control Techniques Simulator

Abstract

Elevator or is one of the tools that serves to facilitate human activities whose routines are more often in a storied room. The existence of this elevator is a substitute for the function of the stairs in reaching each subsequent floor in a multi-storey building. This study simulates a 5-floor elevator control circuit using electrical control techniques simulator software. The use of this application is very helpful for simulating control circuits before the equipment is installed and assembled. Useful for minimizing failures and troubleshooting of the circuit. Based on the results and discussion of the research, there are three main circuits in the control circuit, the new contact circuit and the power circuit. The connection of the power circuit to the motor between the UP contactor and DOWN contactor is not the same. UP contactor connection and motor (R and U), ( V and T ), (T and W). While DOWN contactor and motor (T and U), (V and R), (R and W). This circuit is commonly called an interlock circuit in which the two auxiliary contacts are locked between the auxiliary contact (R. NC) and the auxiliary contact (F.NC) which ensures that they cannot work simultaneously. The process of the elevator going up (UP) has been successful and shows a simulation of the lit going up and without any errors. And the elevator down (DOWN) process has been successful and shows the simulation of the lit going up and up without any errors

References

[1] Sudaesi, Abdurrohman, Giri Wahyu Wiriasto, and Paniran Paniran. "Rancang Bangun Simulator Pengendalian Lift 6 Lantai Berbasis Plc." Jurnal Teknologi Informasi, Komputer, dan Aplikasinya (JTIKA) 4.1 (2022): 97-106.
[2] Paulang, Hipolitus. Perencanaan Passanger Elevator Kapasitas 1600 Kg Pada Ketinggian 3 Lantai Dengan Menggunakan Mesin Penggerak Berjenis Gearless (Studi Kasus Gedung Rsud Undata Palu). Diss. Universitas Tadulako, 2020.
[3] Nurdin, Rosiyan. "Perencanaan Elevator (LITF) Kampus Sekolah Tinggi Teknologi Industri Bontang (STTI Bontang) Lantai Enam Dengan Kapasitas Delapan Orang." Jurnal Teknik Juara Aktif Global Optimis 2.1 (2022): 62-70.
[4] Maulana, Pitu, and Joko Sutopo. Rancang Bangun Elevator Berbasis Arduino. Diss. University of Technology Yogyakarta, 2018.
[5] Andani, Gita Ayu. "Prototipe kendali lift penumpang 4 lantai berbasis PLC." SKRIPSI Mahasiswa UM (2022).
[6] Pratama, Galeh Nur Indriatno Putra, and H. Sumarjo. "Aksesibilitas Tata Letak Elevator Penumpang Gedung Kantor Pusat Layanan Terpadu (KPLT) Fakultas Teknik UNY." INERSIA: lNformasi dan Ekspose hasil Riset teknik SIpil dan Arsitektur 14.1 (2018): 26-35.
[7] Afifah, Aisyah Fitri, and Nugroho Hartono. "Analisa Kebutuhan Dan Manajemen Pemeliharaan Elevator Pada Gedung Perum Perhutani Unit I Jawa Tengah." Wahana Teknik Sipil: Jurnal Pengembangan Teknik Sipil 22.1 (2017): 17-28.
[8] WAFA, ABI. Desain Mechanical Electrical Pada Gedung Pasca Sarjana Unisnu Jepara Untuk Menentukan Kapasitas Panel Surya. Diss. UNISNU Jepara, (2018).
[9] M. D. Sebayang, Cara Kerja dan Perbaikan Lift pada Gedung BUMN. Jakarta: Teknik Mesin Universitas Peradaban, (2013).
[10] Wu, Kai Fa, et al. "Design of Machine Operating Panel based on CAN Bus for the PC-based CNC System." Advanced Materials Research. Vol. 819. Trans Tech Publications Ltd, (2013).
[11] Z. Astamar, Mekanika Teknik 1. Jakarta: Erlangga, (1992).
[12] Budiarti, Erlin. Studi kualitas transportasi vertikal lift (elevator) pada gedung RSUD Bangil 2 di kabupaten Pasuruan. Diss. Universitas Negeri Malang, (2009).
[13] Nishar, Nadia Utami, and Andi Tenrisukki. "Analisis Kebutuhan Dan Manajemen Pemeliharaan Elevator Gedung Kementrian Dalam Negeri Republik Indonesia." TERAS JURNAL 11.1 (2021): 149-156.
[14] Lumenta, Arie SM. "Perancangan Dan Simulasi Perangkat Lunak Sistem Kontrol Lift." Jurnal Teknik Elektro dan Komputer 3.1 (2014): 87-97.
[15] Burhanuddin, Muhammad Aji. Simulasi Pembuatan Miniatur Lift 3 Lantai Dengan Menggunakan Sensor Load Cell Dan Infrared Berbasis Programmable Logic Controller (PLC) Schneider Tm221ce16r Dan Human Machine Interface (HMI). Diss. undip, 2018.
[16] Huang, Qiang, Jianmin Cao, and Ruize Sun. "Design and Implementation of an Elevator Power Failure Warning System." Journal of Physics: Conference Series. Vol. 1621. No. 1. IOP Publishing, 2020.
[17] He, H., Long, Y., & Yu, W. (2021, March). Design and simulation of elevator emergency system based on TIA Portal V15. 1. In Journal of Physics: Conference Series (Vol. 1802, No. 4, p. 042089). IOP Publishing.
[18] Winarno, Yoyok. "Sistem kontrol kecepatan Motor Dc pada Lift Konvensional Dengan Kontrol Linier Quadratic Regulator (LQR) Berbasis Arduino Uno." JURNAL TEKNIK ELEKTRO 9.2 (2020).
[19] Sopandi, Imaludin. Perancangan Sistem Keamanan Elevator dengan Metode Strain Controlled Berbasis PLC. Diss. Universitas Jenderal Soedirman, 2020.
[20] Chamdareno, Prian Gagani, Erwin Dermawan, and Hendra Octafriandi. "Desain dan Analisa Permanen Magnet Motor Sinkron untuk Aplikasi pada Lift." RESISTOR (elektRonika kEndali telekomunikaSI tenaga liSTrik kOmputeR) 2.2 (2019): 113-120.
[21] Wahidani, Endang. Pengaruh Implementasi Software Electrical Control Techniques Simulator (Ekts) Dalam Praktikum Sistem Kontrol Instalasi Motor Listrik Tiga Fasa Terhadap Hasil Belajar Siswa Kelas Xi Smk Pab I Helvetia. Diss. UNIMED, 2017.
[22] Ahyadi, Zaiyan, Sarifudin Sarifudin, and Ivan Maududy. "Rancang Bangun Simulator Sistem Kontrol Elevator 3 Lantai." Poros Teknik 10.2 (2018): 82-29.
[23] Sudaesi, Abdurrohman, Giri Wahyu Wiriasto, and Paniran Paniran. "Rancang Bangun Simulator Pengendalian Lift 6 Lantai Berbasis Plc." Jurnal Teknologi Informasi, Komputer, dan Aplikasinya (JTIKA) 4.1 (2022): 97-106.
[24] Anggraini, Maharani Ongky, and Antonius Suhartomo. "Perancangan Sistem Deteksi Dini Lift Barang Berbasis Arduino di PT Dharma Electrindo Manufacturing." Journal of Electrical and Electronics Engineering 2.1 (2019): 32-41.
[25] Septiawan, Muhammad Hendrik, Dadang Suherman, and Prihadi Murdiyat. "Perencanaan Eskalator Lantai Satu ke Dua pada Gedung Direktorat Politeknik Negeri Samarinda dengan Kendali PLC." J. Tek. Mesin (2020).

Published

2022-05-30

How to Cite

[1]
M. Z. Alfariki and R. Mubarok, “MODELING THE CONTROL PANEL CIRCUIT FOR NICE 3000 ELEVATOR 5 FLOORS USING ELECTRICAL CONTROL TECHNIQUES SIMULATOR SOFTWARE”, jeepa, vol. 2, no. 1, pp. 80–86, May 2022.